We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Products
Hylomar Gasket 2000
Anaerobic curing flexible gasket compound
Hylomar Gasket 2000 is a formed in place (FIP) single component anaerobic curing flexible sealant, which cures in the joint to form a flexible plastic seal. The product is designed to replace traditional solid gaskets.
The thixotropic properties of Hylomar Gasket 2000 prevent migration of the sealant before or during curing. Once cured the compound is resistant to shock and vibration from –50°C to 150°C.
Hylomar Gasket 2000 should be applied to a clean and dry metal surface. The compound may be dispensed by hand from a cartridge or concertina packs. Automated application is also widely used via xy plotter, robot arm or via a silk screen printer. Once applied the joint should be assembled without undue delay. Any excess compound can be easily wiped off external surfaces using Hylomar Rally Wipes.
If joints are dismantled for service or repairs, the cured product can be easily removed and surfaces cleaned for fresh application by using Hylomar Gasket Remover or Hylomar Rally Wipes.
Product Sizes
Pack sizes – 50ml and 250gTypical Application
Typical applications include structural gasketing of engines and transmission components and for general engineering uses. Hylomar Gasket 2000 will seal against gases, water, LPG, hydrocarbons, oils and many other chemicals.
Typical Physical Properties
| UNCURED PRODUCT | |
| Composition | Anaerobic Methacrylate |
| Colour | Ivory - cream |
| Viscosity @ 25°C Brookfield Spindle 6 @ 20rpm | 85,000 + or – 15,000 cps |
| Max diameter of thread/gap filling | 0.50 mm (if used with primer) |
| Solvent Content | None |
| Specific Gravity g/ml @ 25°C | 1.04 |
| Flash Point | >100°C |
| CURED PRODUCT | |
| Average Cure Time | 1 hour |
| Functional Cure Time | 3-6 hours |
| Full Cure Time | 24 hours |
| Elasticity | 82% |
| Shear Strength (DIN 54452) | 4 – 7 N/mm² |
| Tensile Strength | 2.5 – 4 N/mm² |
| Shock strength | 2 – 4 N/mm² |
| Temperature Range | -50°C + 150°C |
Technical & Safety Documents
Other languages available upon request
Enquire About This Product
Similar Products
